Rockwell Automation LDL Ironless Linear Servo Motors - Manual (Page 23)

Publication LDL-UM001A-EN-P - March 2009 23
Installing the LDL-Series Linear Motor Chapter 3
2. Verify installation envelope dimensions.
See table on page 23.
3. Install the first magnet channel.
Tighten but do not torque screws.
Mounting Configuration A Mounting Configuration B Mounting Configuration C
W1
0.10 mm (0.003 in.)
0.83
±
0.30 mm (0.003
±
0.011 in.)
J
Coil Cat. No. Dimension H
mm (in.) Magnet Channel
Cat. No. Dimension W
mm (in.)
LDL-x 030xxx-xxxxx 80.0 (3.15)
LDL-NM030xxx
LDL-NM050xxx
36.4 (1.43)
LDL-x 050xxx-xxxxx 100.0 (3.94)
LDL-TM030xxx
LDL-TM050xxx
37.7 (1.48)
LDL-x 075xxx-xxxxx 130.0 (5.12)
LDL-NM075xxx 38.05 (1.50)
LDL-TM075xxx 39.35 (1.55)