Rockwell Automation LDL Ironless Linear Servo Motors User Manual
Page 24
24
Publication LDL-UM001A-EN-P - March 2009
Chapter 3 Installing the LDL-Series Linear Motor
4. Install additional magnet channels.
Place a magnet channel on the mounting surface at a distance
from the previously installed magnet channel and slide it into
position.
5. Align the magnet channels with an aluminum straight edge and
the alignment tool and tighten the screws.
a. Place the alignment tool in the alignment hole at the butting
end of the first two magnet channels.
b. Align the edges of the magnet channel with the aluminum
straight edge and tighten the screws.
c. Repeat alignment between the fixed magnet channel and the
next magnet channels needing alignment until all the magnet
channels are tightened.
6. Torque all the screws to values listed in the table on
page 22
.
7. Remove the alignment tool.
2
3
4
Aluminum straight edge
Alignment tool