Rockwell Automation LDL Ironless Linear Servo Motors - Manual (Page 77)

77 Publication LDL-UM001A-EN-P - March 2009 77
Appendix
C
Sin/Cos Linear Encoder and Kinetix 6000
Drives
Introduction This appendix guides you through commissioning a linear motor with
a Sin/Cos 1V peak-to-peak output linear encoder.
Kinetix 6000 Drive
Feedback Connection For robust operation when interfacing your Sin/Cos 1V peak-to-peak
differential output linear encoder to a Kinetix 6000 drive, you should
terminate the sine and cosine signals as follows.
For systems where the cable length is less than 10 m (32.8 ft), the
encoder power supply from the Kinetix 6000 drive feedback
connector should be dropped from its nominal 5.4…5.1V DC volts
with the addition of a Shottky Diode, see schematic.
Topic Page
Kinetix 6000 Drive Feedback Connection 77
Encoder Counting Direction 78
Set Up the Axis Properties 78
BM+
BM-
AM+
AM-
150 7
1/4 W, 5%
150 7
1/4 W, 5% 4
3
2
1
1N5819,
14 (~5.1V DC) (5.4V DC) +5V DC
COS-
COS+
SIN+
SIN-
2090-K6CK-D15M
Feedback Connector
Low Profile Connector
Add a Shottky diode for cable
lengths less then 10 m (32.8 ft).
or equivalent
Resistor
Resistor