Rockwell Automation LDL Ironless Linear Servo Motors - Manual (Page 32)

32 Publication LDL-UM001A-EN-P - March 2009
Chapter 5 Wiring the LDL-Series Linear Motor
e. Do not apply excessive force when mating the cable and
motor connectors. If the connectors do not go together with
light hand force, realign and try again.
f. Hand tighten the knurled collar with five to six turns to fully
seat the connector.
Encoder
Connector
Power
Connector
Feedback
Connector
Connect your encoder using
Encoder Connector Kit, catalog
number LDC-ENC-CNCT.
Power Extension Cable
2090-CPWM4DF-xxAFxx or 2090-XXNPMF-xxSxx
Feedback Extension Cable
2090-CFBM4DF-CDAFxx or 2090-XXNFMF-Sxx
To User Supplied Encoder
To Drive
ATTENTION
Be sure that cables are installed and restrained to prevent
uneven tension or flexing at the cable connectors. Excessive
and uneven lateral force at the cable connectors may result in
the connector’s environmental seal opening and closing as the
cable flexes. Failure to observe these safety precautions could
result in damage to the motor or encoder.
ATTENTION
Keyed connectors must be properly aligned and hand-tightened
the recommended number of turns.
Improper alignment is indicated by the need for excessive force,
such as the use of tools, to fully seat connectors.
Connectors must be fully tightened for connector seals to be
effective.
Failure to observe these safety precautions could result in
damage to the motor, cables, and connector components.