Rockwell Automation 1440-RMA00-04RC XM-440 Master Relay Module - Manual (Page 22)

Rockwell Automation Publication GMSI10-UM009D-EN-P - June 2011
22 Installing the XM-440 Master Relay Module
1. Position the terminal base on the 35 x 7.5mm DIN rail (A).
2. Slide the terminal base unit over leaving room for the side
connector (B).
3. Rotate the terminal base onto the DIN rail with the top of the rail
hooked under the lip on the rear of the terminal base.
4. Press down on the terminal base unit to lock the terminal base on the
DIN rail. If the terminal base does not lock into place, use a screwdriver
or similar device to open the locking tab, press down on the terminal
base until flush with the DIN rail and release the locking tab to lock the
base in place.
Position terminal base at a slight angle and hook over the top of the DIN rail.