Rockwell Automation 1440-RMA00-04RC XM-440 Master Relay Module User Manual
Page 37
Rockwell Automation Publication GMSI10-UM009D-EN-P - June 2011
Installing the XM-440 Master Relay Module 37
1. Make certain the keyswitch (A) on the terminal base unit (C) is at
position 2 as required for the XM-440.
2. Make certain the side connector (B) is pushed all the way to the left.
You cannot install the module unless the connector is fully
extended.
3. Make sure that the pins on the bottom of the module are straight so they
will align properly with the connector in the terminal base unit.
4. Position the module (D) with its alignment bar (E) aligned with the
groove (F) on the terminal base.
5. Press firmly and evenly to seat the module in the terminal base unit. The
module is seated when the latching mechanism (G) is locked into the
module.
6. Repeat the above steps to install the next XM-440 module in its terminal
base.