Insert edit mode – AJA KONA 5.0 User Manual
Page 108
98
Immediately under the scrub bar are standard tape deck icons providing hot buttons for the
Play process. They are:
The slider on the bottom is a variable speed forward/reverse control. Positions from left to
right are: (Reverse) 16x, 8x, 4x, 2x, 1/2, 1/4, Still, (Forward) 1/4, 1/2, 2x, 4x, 8x, and 16x.
Output Mode
Use the Mode pull-down at the bottom of the KONA Options tabbed menu
to select Output mode.
Note: The Playback Options pane is disabled in this mode to prevent format changes during
output.
Standard VTR controls and machine control timecode hot-text are provided for outputing
your segment. A pull-down menu beneath VTR Status allows you to choose between two
modes of output— Insert Edit or Print-To-Video. Print-To-Video and Insert Edit will output the
loaded clip from its in/out- points (if any exist) or from the first to last frame (if no in/out-
points are set).
Insert Edit Mode
In this mode, you can select the Video/Audio content that you want to insert by checking the
desired content boxes at the left. Then set an in-point that the recording VTR will use to
initiate recording of your segment. Duration is determined by the length of the clip you are
outputting.
Insert Edit Mode
Note: The Preview Edit check-box controls whether the insert edit is in “Preview” mode or
not. In preview mode, the deck never goes into record but just simulates the edit without
putting anything to tape. You must uncheck this box to perform the actual Insert Edit.
Go-to-Previous “Most Significant” frame
Reverse 1 frame
Rewind (8x)
Reverse Play
Still
Stop
Play (1x)
Fast Forward (8x)
Forward 1 frame
Go-to-next “Most Significant” frame