AJA KONA 5.0 - Manual (Page 64)

54
Capture In/Out Mode
The capture in-point is entered by clicking on the left field of eight digits. The out-point can
be set by clicking on the right field of eight digits. Alternatively, you can specify a duration in
the Duration field and the in- or out-point (whichever you have not entered) will be entered
automatically according to duration.
Note: The in-point/out-point field values are inclusive. If both are set to the same value, the
capture duration will be 1 frame.
To load the current VTR timecode setting in either field (in-point or out-point) click on the hot
text field and enter from your keyboard.
Note: When a hot text field has a dotted underline, you can left-click and hold on the field
and drag your curser to increment or decrement the value.
VTR TC
The current VTR timecode is displayed on the bottom of the control pane and you can click on
it and enter a timecode to perform a seek to that timecode on the VTR. The VTR must be
online and in remote rather than local control mode (as reported to the left of the current
timecode).
Capture/KONA Status
Click on the hot toggle buttons of the Status header to switch between Capture Status and
KONA Status. Capture Status reports current state of activity, capture duration and number of
frames captured in ( ), and the number of frames that may have been dropped.
KONA Status reports Active/Inactive status, Primary Format setting, Video Input type, and
Audio Input type.