Preview options – AJA KONA 5.0 User Manual
Page 115
1
105
Installation and Operation Manual — Using Eyeon Fusion
Under Globals and new comp defaults->Preview select AJA Preview from the “Display file
sequences on:” pull-down menu. To set up AJA Preview formatting, continue down to the I/O
selections under Globals and new comp defaults and then choose AJA Preview.
AJA Preview Setup Menu for Fusion
Preview Options
If there is more than one AJA capture device installed in your system, a pull-down menu at the
top allows you to select which device to control (subject to Activation rules).
In Preview Options, you can change the Primary and Secondary video signal formats and
Analog output type (as applicable), and select timing Reference mode—Free Run, External
(genlock), or from the video Input signal.
Finally, for picture quality adjustment, you can output a Test Pattern selection using the pull-
down menu under Test Options. Click OK to output your Preview.
Note: Fusion AJA Preview, in most cases, will not be in realtime for any RAM Preview.