AJA KONA 5.0 User Manual
Page 30
20
Note: Always put the RAID controller and KONA on separate PCI busses. This improves
performance by reducing bus contention.
KONA Card placement in HP XW8200 Motherboard
6. Open the card retainer bar on the left side of the chassis cardcage. Remove the card
edge access cover from the desired slot where you will be inserting the KONA card.
7. Holding the KONA card by the card edge plate and an outside edge, carefully insert
the KONA card by rocking it slowly into the slot. Ensure the card edge aligns properly
with the PC’s opening (where the card edge cover was just removed) and that it is
fully seated in the slot.
8. Secure the card in the slot replacing the card retainer bar.
9. Replace the PC’s panel/door removed in step 3.
Locate the correct PCI Slot and Insert the KONA Card (typical installation shown)