Baumfolder 714XA - Manual (Page 10)

TP10583 PAGE 7
INTRODUCTION OVERVIEW
The 714XA consists of the following major compo-
nents:
Figure 2
Figure 1
TRANSPORTATION/INSTALLATION
As soon as you receive your new folder, and before
removing the machine from the skid, check carefully for any
damage to the shipments. If any damage is found, promptly
contact your Baumfolder sales representative.
To lift the folder from the skid, place the fork lift rails
under the lower rails as shown in Figure 2. Note that the
fork lift must have at least a 1500 lb. capacity.
Remove all rust protection coating after unpacking the
folder.
WARNING
Do not plug the power cord into an AC outlet until the
714XA is fully assembled, adjusted and ready to use. Unplug
the 714XA an time disassembly is required.
ASSEMBLY INSTRUCTIONS
1.0
SET MAIN UNIT ON TOP OF CART ASSY
Note orientation in Figure 3. The covered end of the
cart with the oval cut out for the pump power cord should be
directly below the power entry bracket mounted in the left
lower edge to the front guard.
Align inside of each frame to the four brackets on top
of the cart assembly and attach with (8) M6 internal tooth
lock washers (260-304-09-00) and (8) socket head M6x10
screws (262-320-04-00).
1 main unit w delivery table
2 cart w pump
3 feed table
4 pan 1
5 pan 2
6 stacker tray
7 accessories kit
1
2
3
4
5
6
Figure 3
BRACKET
CUTOUT