Baumfolder 714XA - Manual (Page 38)

PAGE 35 TP10583
E.) Now turn the handwheel, and make sure that the edge of the paper hit
at all points on the paper stop simultaneously.
F.) Confirm the squareness of the side guides to the fold rolls and the
sheet to the paper stop by turning the handwheel so that the sheet is
folded. Sheet should be folded straight.
G.) Using the Operator Control panel, select a double parallel fold and
enter proper sheet length.
H.) Handfeed a sheet into the nip of the fold rolls.
C.) Turn the handwheel until the sheet is just shy of touching the paper
stop of the #2 fold pan.
D.) Adjust the skew of the #2 fold pan paper stop by turning the skew
adjust thumb screw on the paper stop until it is parallel with the sheet.
E.) Now turn the handwheel, and make sure that the edge of the paper hit
at all points on the paper stop simultaneously.
F.) Confirm the squareness of the side guides to the fold rolls and the
sheet to the paper stop by turning the handwheel so that the sheet is
folded. Sheet should be folded straight.
5.) Confirming the calibration of the #1 Fold Pan:
All though a set of calipers is not a requirement, they are recommended to
measure the fold lengths of the sheet and to aid you in adjusting the
position of the paper stop’s home position. They will give you a more
accurate measurement.
A.) Load a stack of test paper into the feeder.
Note: Using stock that has print on it, or has been marked in some
way will aid you in determining which edge is the leading edge of the
sheet and which direction the paper stop needs to be adjusted.
B.) Using the Operator Control Panel, select a half fold and enter the
proper sheet length when prompted to do so.
C.) Run a single test sheet. If the sheet is folded exactly in half then
proceed to Step #6. If the sheet is not folded exactly in half, then
proceed to Step #5.D.
D.) Measure how much the folded length is off and note this for the
adjustment later. Also note if the fold is to long or short.
E.) Remove the #1 fold pan from the folder.