Baumfolder 714XA - Manual (Page 48)

PAGE
45 TP10583
INSTALLATION OF ANTISTATIC KIT:
1. Attach the ring terminal end of the antistatic kit to the existing stacker hardware:
A. Loosen the #4 nut closest to the unit that secures the black plastic enclosure
to the inside of the stacker.
B. Next remove the now loose #4 black screw closest to the main unit.
C. Add a #4 external lock washer against the outside of the now open hole.
D. Stack the ring termal on top of the #4 external lock washer.
E. Add a second #4 external lock washer on top of the ring terminal.
F. Now thread the removed #4 black screw back through the stack (including the
black plastic enclosure.)
G. Finish by returning and tightening the #4 nut on the inside original position.
2. Attach the opposite end of the antistatic kit to the inside of the non-operator side frame using the magnet:
A. Be sure not to block the hole in the frame for the exit sensor (red).
B. Orient magnet so the cord is close to the rolls.
C. Be sure there is clearance between the gears and the cord.
D. Rotate the magnet so that the folded paper passes just above the cord.
3. Attach the other magnet to the inside of the operator side frame:
A. Align the second magnet straight across from the first magnet.
B. Orient magnet so the cord is close to the rolls.
C. When changing paper weights the magnets may need to be rotated to stay just
under the stream of folded paper.