Baumfolder 714XA - Manual (Page 27)

PAGE 24 TP10583
29. The Save Screen
Use the Job Memory to select a location first (See 28.) On the save screen enter the speed the job was run
before saving.
Pressing the save button: moves the current pan locations, fold type, and speed into the selected
memory location.
30. The Reload Screen
Use the Job Memory to select a location first (See 28). Press the reload button: to move data from
memory to current active values on the production screen. Please remember to manually set the pot to the saved
speed shown on the reload screen before returning to the production screen.
31. Status States:
Fault states include:
This indicates the emergency stop button is triggered and needs to be pulled to reset.
This indicates an AC drive fault. Turn power "off", allow the power to discharge, and
then turn it back "on".
This indicates a paper jam on the delivery table. The jam must be removed before this fault
can be cleared. Then go to the production screen and press this image on the lower left corner of the
screen to reset.