Baumfolder 714XA - Manual (Page 11)

PAGE 8 TP10583
1.1
INSTALL FEED TABLE
See Figure 4. Place feed table with feed wheel toward
the rolls. Slide the front knotch onto locating pins (1) and
rotate the back end of the table downward to rest on upper
dowel pins (2). Identical pins on both frames.
Rotate the handwheel to make sure the gears mesh.
Identify cable connected to the bottom of the feed table.
Engage the other end of this cable to the mating circular din
connector mounted in front frame. Turn rotating collar CW to
lock in place.
1.2 I
NSTALL BOTH FOLD PANS
The fold pans are identical.
See Figure 5 for positioning:
Pan 1 sets on pins 1 and 2
Pan 2 sets on pins 5 and 6
Rubber hold downs 3 and 7
Pan 1's mating connector is 4
Pan 2's mating connector is 8
Insert one pan into pan 1 position. With motor end of
pan towards the person installing the pan, angle front end
down and set onto locating pins (1). Rotate back end down
until center knotch is seated onto second set of locating pins
(2). Two rubber hold downs on top of the pan now need to
be rotated into position to hold the pan (3). Locate a cable
attached to the back end of the pan and engage the opposite
end into the mating circular din connector near the top of
the front frame (4). Rotate this collar CW to lock in place.
Repeat for pan 2 execept angle front end of this pan
upward. Engage its cable connector into mating connector
about half way down the left edge of the front frame (8).
Figure 4
1 2
Figure 5
1
2
3 4
5
6 7 8
M ANUALLY TURN THE HAND WHEEL AFTER INSTALLING
BOTH PANS TO MAKE SURE NEITHER PAN IS RUBBING
AGAINST THE ROLLS
.