Baumfolder 714XA - Manual (Page 42)

PAGE 39 TP10583
Q.) Loosen nuts holding the home position switch to it’s bracket.
R.) Manually move the paper stop assembly away from home position so
that you have 0.25”(6.35mm) gap between the heads of the home
position screws and the lower half pan brace. A 1/4” allen wrench
may be used to aid in getting the proper distance.
Note: This dimension is critical. The software is programmed so that
the paper stop must travel 0.25”(6.35mm) from the time when the
home position switch is tripped until the paper stop reaches home.
Any variation in this distance may cause the fold lengths to be off.
S.) Move the home position switch so that the paper stop assembly trips
at the position described in Step #5.R and tighten nuts holding
switch.
T.) The deflector pusher will now need to be reset as described in Steps
#1.I - 1.O.
U.) Place pan back into machine.
V.) Turn power off and back on.
W.) Choose to initialize the folder when prompted to do so by the
Operator Panel Display.
Note: This must be done each time the paper stop’s home position
has been changed in order for proper functioning of the fold pan.
X.) Select a half fold and enter the proper sheet length.
Y.) Run a test sheet to check that the sheet is folded in half.
Z.) If the sheet is folded exactly in half, then proceed to Step #6. If the
sheet is not folded exactly in half, repeat Steps #5.D - 5.Y.
6.) Confirming the calibration of the #2 Fold Pan:
A.) Using the Operator Panel, move the #1 fold pan into deflect, and
move the #2 fold pan to the position that is half of the length of the
test sheets you will be using to calibrate the fold pans. For example,
if you are using 11” long paper, then set the #2 fold pan at 5.50”
B.) Run a single test sheet. If the sheet is folded exactly in half then the
machine is ready to run production. If the sheet is not folded exactly
in half, then proceed to Step #6.C.
C.) Measure how much the folded length is off and note this for the
adjustment later. Also note if the fold is to long or short.
D.) Remove the #2 fold pan from the folder.