Baumfolder 714XA - Manual (Page 37)

TP10583 PAGE 34
H.) Loosen both front and rear thumb screws on the operator side guide.
I.) Push in and rotate the operator side guide skew adjust knob so that the
side guide skews in the direction the sheet was being off square to the
fold rolls.
J.) Now repeat steps #3.E - #3.G until the sheet is square to the fold rolls.
K.) Once the sheet is square to the fold rolls, hold the skew adjust knob in
place and loosen the set screw for the operator side guide skew adjust
knob.
L.) Now rotate the collar so that the slot in the collar slips over the nipple
on the operator side guide skew adjust knob.
M.) Tighten set screw in the collar.
N.) Place a stack of 10 sheets into the feeder.
O.) While holding the non-operator side of the stack of paper up, move
the non-operator side guide so that the clear mylar plastic piece on
the side guide is under the stack.
P.) Now adjust the non-operator side guide up to the stack of paper so
that side guides do not allow the sheet to move side to side, but not so
tight that the stack of paper is pinched by the side guides.
-If the side guides are to loose, the side guides will not properly
register the sheets and the folds will not be consistently square.
-If the side guides are to tight, the side guides will prevent the
sheets from being fed into the fold rolls.
Q.) Adjust the skew of the non-operator side guide, so that the side guide
is parallel to the stack of paper.
-If you have to adjust the skew of the non-operator side guide,
follow the same procedure for adjusting the side guide skew adjust
knob and collar on the operator side guide.
4.) Ensure the fold pan paper stops are square to the sheets:
A.) Using the Operator Control panel, select a half fold and enter proper
sheet length.
B.) Handfeed a sheet into the nip of the fold rolls.
C.) Turn the handwheel until the sheet is just shy of touching the paper
stop of the #1 fold pan.
D.) Adjust the skew of the #1 fold pan paper stop by turning the skew
adjust thumb screw on the paper stop until it is parallel with the sheet.