Baumfolder 714XA - Manual (Page 12)

TP10583 PAGE 9
1.3 I
NSTALL STACKER TABLE TRAY
To install the stacker table tray, loosen the knobs on
either side of the tray. Drop the tray over the knobs and
retighten.
1.4 P
UMP
C
ONNECTIONS
1.41 PNEUMATIC CONNECTIONS
SEE FIGURE 7
Attach the vacuum side of the pump to the white elbow
at (1A). A second 1" hose should connect from the white
connect (1B).
The blow hose from the pump should connect to the
black connector at (2A). A second 1" hose should connect
from black connector to fitting on the solenoid manifold (2B).
Figure 7
1.42 ELECTRICAL CONNECTIONS
The pump has a plug/cord set attached. This plug fits directly
into the receptacle mounted in a bracket with a cut out in the
lower left side of the front guard. See figure 3.
1.5 SLITTER SHAFT INSTALLATION
To Install the slitter shaft, hold it with the grooves in the
boxing down. Be sure the slitter shafts are free turning.
Insert the slitter shaft and seat the grooves in the boxings
on the lower locating pins in the side frames.
Check for proper gear engagement between the upper
slitter shaft gear and the 19-tooth frame idler gear by turning
the hand wheel.
1.6 O
THER
C
ONNECTIONS
Refer to the serial number plate for electrical
requirements. The serial number plate notes the voltage,
phase and hertz, total machine amperage, and minimum wire
conductor size for the main power connection.
For the 110VAC 60 Hz version a 20A dedi-
cated line is required.
All electrical connections are to be made by a certified
electrician. Refer to local building electrical codes for proper
and safe connections.
2.0 SETUP
2.1 GAP ADJUSTMENT
The orange tab above the sucker wheel assembly on the
feed table must be adjusted for each new weight of paper
See Figure 8.
Slide two sheets of paper between the tab and the
sucker wheel (or fold a single sheet and use the double
thickness). Turn the gap knob (1) counter clockwise to
tighten until there is a slight drag on the paper when you
pull the double thicknes of paper away from the orange tab.
Remove the paper. The correct gap is now set.
2.2 FEED TABLE ADJUSTMENT
On the paper feed table there are two guides which keep
the stack of paper properly aligned for feeding into the
folder. Adjust these guides to correspond with the different
widths of paper being fed. See black bars in Figure 8.
To adjust the paper feed guides, loosen the two side
guide locking knobs on each guide (2). Slide the guides
from side to side until the inside edge of each guide is
aligned with the number correponding to the width of the
paper being folded.
Square the guides to the rolls using a sheet of paper.
Lay a sheet of paper in the feeder, close to but not touching
the side guides. Push the sheet down just to the nip of the
rolls. Then align the guide by loosening the adjusting
knobs and aligning the guide so that it is parallel to the edge
of the paper. When one side is square, the other side can be
moved into position.
Tighten the locking knobs to secure the paper guides
into position.
When you load the actual job, you may have to move
these guides slightly to take care of variations in sheet size.
To feed properly, the paper must slide freely between these
guides.
1A
1B
2A
2B
Figure 8
2
1