Baumfolder 714XA - Manual (Page 16)

TP10583 PAGE 13
Before tightening the blade to the collar, slide
the blade with the collar loosely attached on the end
of the shaft. Then tighten securely, thus aligning both
the blade and collar, allowing free horizontal move-
ment along the shaft.
Place the blade, mounted on the collar, on the
upper shaft in the proper position where the cut is to
be made. Then move the blade and collar on the
lower shaft so that the two flat edges of the blades
are pressed snugly together. Too much space
between the blades will produce a ragged cut.
Space the rubber pull-out tires to support the
sheet.
5.0 MAINTENANCE
5.1 Maintenance and Care of your
714XA
The 714XA Air Feed has been designed to
give you years of useful service, provided you
maintain it according to these instructions.
5.2 Lubrication
Apply one or two drops of light machine oil at
all slitter shaft bearings and the feed table bearings
and idler gear once a week. Be sure to keep oil off
any surface which may contact the paper.
5.3 Cleaning of Fold Rolls
Periodically wipe off the rubber surface of the
fold rolls using an approved solvent such as
Surewash or its equivalent. Surewash is available
from BAUMFOLDER in 1-quart (P/N 24108-
001) and 1-gallon (P/N 24108-002) containers. A
complementary bottle of Surewash is included with
your machine.
5.4 Cleaning Filters
The filters on the pump should be checked
periodically and cleaned as needed. The filters can
be reached by unscrewing the filter jars.
5.5 Photo Sensors
Occasionally wipe off the photo sensor with a
dry cloth.