Metrohm 815 Robotic USB Sample Processor XL - Manual (Page 28)

3.4 Mounting the Swing Head to the Sample Processor ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
20 ￭￭￭￭￭￭￭￭ 815 Robotic USB Sample Processor XL
You can open the individual chain links with a screwdriver as follows.
1 Open the guide chain
￭ Insert a screwdriver into the groove located on the side of a chain
link.
￭ Loosen the clip with a forceful leverage movement.
￭ Pull the clip out of the chain by hand.
￭ Repeat the above actions for each chain link.
Figure 11 Guide chain - Opening chain links
2 Insert into the guide chain
￭ Place the required tubings or cables into the guide chain.
3 Close the guide chain
￭ Close the clip for each chain link again by hand and apply forceful
pressure to snap them into place.
Caution
Take care to ensure when mounting tubing and cables that there is no
traction on the drives while moving the lift or swiveling the robotic arm.
This could lead to overloading of and possible damage to the drive.
Remove the clips of the two lowest chain links when you install the
rinsing and aspiration tubing.