Metrohm 815 Robotic USB Sample Processor XL - Manual (Page 5)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭ Table of contents
815 Robotic USB Sample Processor XL ￭￭￭￭￭￭￭￭ III
Table of contents
1 Introduction 1
1.1 The 815 Robotic USB Sample Processor XL in the
Titrando system .................................................................... 1
1.2 Instrument description ......................................................... 2
1.2.1 Model versions ........................................................................ 3
1.2.2 Instrument components .......................................................... 4
1.2.3 Intended use ........................................................................... 5
1.3 About the documentation ................................................... 5
1.3.1 Symbols and conventions ........................................................ 5
1.4 Safety instructions ................................................................ 6
1.4.1 General notes on safety ........................................................... 6
1.4.2 Electrical safety ........................................................................ 6
1.4.3 Tubing and capillary connections ............................................. 7
1.4.4 Personnel safety ...................................................................... 8
1.4.5 Flammable solvents and chemicals ........................................... 9
1.4.6 Recycling and disposal ............................................................. 9
2 Overview of the instrument 10
2.1 Front and rear ..................................................................... 10
2.2 Rear panel ........................................................................... 12
2.3 Sample racks ....................................................................... 13
3 Installation 14
3.1 Setting up the instrument .................................................. 14
3.1.1 Packaging .............................................................................. 14
3.1.2 Checks .................................................................................. 14
3.1.3 Location ................................................................................ 14
3.2 Preparing the Sample Processor ....................................... 14
3.2.1 Connecting a mains cable ...................................................... 14
3.3 Connecting a computer ..................................................... 15
3.4 Mounting the Swing Head to the Sample Processor ...... 17
3.4.1 Mounting the Swing Head ..................................................... 17
3.4.2 Guide chain for cables and tubing ......................................... 19
3.4.3 Mounting the robotic arm reinforcement ............................... 21
3.5 Configuring the robotic arm .............................................. 22
3.6 Mounting the robotic arm ................................................. 24
3.7 Robotic arms with beaker sensor ..................................... 26
3.8 Installing rinsing and aspiration equipment .................... 27