Metrohm 815 Robotic USB Sample Processor XL - Manual (Page 52)

3.18 Mounting the safety shield ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
44 ￭￭￭￭￭￭￭￭ 815 Robotic USB Sample Processor XL
3.18 Mounting the safety shield
Warning
It is imperative that the safety shield be installed before the first time
the 815 Robotic USB Sample Processor XL is used. The device is not per-
mitted to be operated without a safety shield.
1
2
3
Figure 34 Mount the safety shield
Proceed as follows:
1 Loosen the knurled screws on both sides of the tower.
2 Move the safety shield into position, starting from the top. Observe
the corresponding illustration.
3 Fix the safety shield in place with the knurled screws.
Note
You can adjust the vertical position of the safety shield at any time
by loosening the screws. Take care to ensure that is not possible to
reach into the working area of the lift while the instrument is in
operation.