Metrohm 865 Dosimat plus - Manual (Page 62)

6.3 Creating solutions (CNT D) ￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
52 ￭￭￭￭￭￭￭￭ 865 Dosimat plus
Density
Density of the solvent to be dosed.
If selecting unit is: %, mmol/kg, mol/kg or ppm.
Input
10 digits
Range 0.000000001 ... 9999999999 g/mL
Default value 1.0 g/mL
Factor
Multiplication factor for the calculation of the volume to be dosed. The
factor can be used in general as a correction factor, e.g. for compensating
for volume contraction or for specifying the starting concentration.
Input 10 digits
Range 0.000000001 ... 9999999999
Default value 1.0
6.3.4 Dosing parameters
Menu ▶ Parameters ▶ Dosing parameters
Dosing rate
The rate at which dosing takes place. The maximum dosing rate depends
on the cylinder volume (see Chapter 8.1.1, page 61).
Range 0.01 ... 150.00 mL/min
Selection max.
Default value max.
Filling rate
Rate at which the dosing cylinder is to be refilled. The maximum filling
rate depends on the cylinder volume (see Chapter 8.1.1, page 61).
Range 0.01 ... 150.00 mL/min
Selection max.
Default value max.
Volume limit
Safety limit for limiting the maximum volume to be dosed.
Range 0.01 ... 99999.9 mL
Selection off
Default value off
off
No safety limit.