5 configuration, 1 report, Configuration – Metrohm 827 pH lab User Manual
Page 29: Report, 5configuration
5 Configuration
826/827 pH meter, Instructions for Use
21
5
Configuration
The configuration menu contains all the instrument settings for the pH
meter. These are independent of the mode. They continue to exist until
they are edited or the permanent memory containing the instrument
configuration is re-initialized (see Section 8.3).
All the settings of this menu are described in this section. For each
point you will find all the possible entries or the valid entry range to-
gether with the default value. This will always be reset when the perma-
nent memory of the pH meter is re-initialized. The default is written in
bold type below.
Example:
print crit.
immed., time, drift, change, off
The print criterion defines at what point in time the report or the meas-
ured value is being printed. The printing is started immediately with the
default value immed..
5.1
Report
<< config >>
configuration
├
report
│ ├
id
: ├
line feed
├
dev.label
└
sys.test rep.
In the configuration menu report you can define the output format of
the report header.
A
report header containing all the elements described here could look
like this:
Report identification:
'mp
Device identification (unchangeable):
827 pH lab
01106 5.827.0010
Device identification (changeable):
dev.label
lab 1a
Date, Time:
print date
2005-01-25 08:23:56
Remark
id
sample 1
...
id
8 ASCII characters
This is where you can define a short identification for the report header
of the measuring point report and the calibration report (e. g. sam-
ple/electrode identification). This entry will be printed out only if an iden-
tification has been entered. This identification is saved with each meas-
ured value being stored (see Section 7.2) in order to label the measured
values individually.