Metrohm 827 pH lab - Manual (Page 42)

6.2 Temperature measurement (T mode)
34
826/827 pH meter, Instructions for Use
temperature
The calibration temperature is shown here.
temp.sensor
If the calibration temperature has been determined automatically by a
connected temperature sensor then its type will be shown here ('NTC'
or 'Pt1000'). A manually entered temperature for the calibration will be
indicated accordingly ('manual').
cal.date
The date of the calibration is shown here.
cal.time
The time of the calibration is shown here.
cal.interval
If a calibration interval has been defined under param/cal.settings
then it will be shown here. It can be used together with the calibration
time to estimate the time that the next calibration is due.
buff.type
The type of buffer defined in the calibration parameters at the time
when calibration was carried out is shown here.
no.of buffers
The number of buffers actually measured is shown here. This can be
lower than that given in the calibration parameters, as a calibration can
be terminated prematurely with <QUIT>; only the buffers which have
already been measured will then be used for the calculation of the cali-
bration data.
6.2 Temperature measurement (T mode)
No editable parameters are necessary for this measuring mode. The
menu << param >> can therefore not be selected.
6.3 Potential measurement (U mode)
No editable parameters are necessary for this measuring mode. The
menu << param >> can therefore not be selected.