Metrohm 827 pH lab - Manual (Page 30)

5.2 Printing out measured values
22
826/827 pH meter, Instructions for Use
line feed 0...3...999
The paper feed of the printer at the end of a report can be set here. You
can select the number of empty lines so that after the report has been
printed out you can tear off the printed paper directly at a suitable point.
The paper feed depends on the type of printer and has to be set accor-
dingly.
Note!
The line feed must be set to 999 when using a A4 printer.
dev.label 8 ASCII characters
If you wish to assign the printed reports to a particular pH meter not on-
ly by the unchangeable device identification, you can enter any text
here. This entry will be printed out in each report provided that an identi-
fication has been entered.
sys.test rep. on, off
After switching on the 826/827 pH meter a system diagnosis is carried
out automatically. If this parameter is switched on, the result is printed
automatically after switching on the pH meter.
5.2 Printing out measured values
<< config >> configuration
:
├
print
: └
print crit.
┬
immed.
┬
date & time
│ ├
rep.header
│ └
cal.report
├
time
┬
date & time
│ ├
rep.header
│ ├
cal.report
│ ├
time int.
│ └
stop time
├
drift
┬
date & time
│ ├
rep.header
│ └
cal.report
├
change
┬
date & time
│ ├
rep.header
│ ├
cal.report
│ ├
delta pH/T/mV
│ └
stop time
└
off
In the configuration menu print the output form of measured values,
triggered by <OK> in the menu << print >> is defined.
print crit.: immed., time, drift, change, off
Depending upon the print criterion a measured value report will be
transmitted to a printer either immediately, at defined time intervals,