Cisco 7912G - Manual (Page 65)

3-3
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SIP), Cisco Unified IP Phones
OL-8131-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Before You Begin
Safety
Review the following warnings before installing the Cisco Unified IP Phone. To
see translations of these warnings, refer to the Regulatory Compliance and Safety
Information for the Cisco Unified IP Phone 7900 Series document that
accompanied this device.
Warning Read the installation instructions before you connect the system to its power
source.
Warning Only trained and qualified personnel should be allowed to install, replace, or
service this equipment.
Table 3-1 Configuration Activities
Activity Explanation Reference
Auto-registration. If you plan to use auto-registration,
verify that it is enabled and properly
configured in
Cisco Unified CallManager before
connecting any Cisco Unified IP Phone
to the network. See the “Adding Phones to the
Cisco Unified CallManager
Database” section on page 2-12
.
Configure and assign
telephony features. You must use
Cisco Unified CallManager
Administration to configure and assign
telephony features to the Cisco Unified
IP Phones. See the Chapter 5, “Configuring
Telephony Features.”
Add and associate
users. In Cisco Unified CallManager
Administration, you can add users to
the database and associate them with
specific phones. In this way, users gain
access to web pages that allow them to
configure phone options such as call
forwarding and speed dialing. See the Cisco
Unified CallManager
Administration Guide.