Cisco 7912G - Manual (Page 86)

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Network Configuration Menu Parameter Descriptions
4-12
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SIP), Cisco Unified IP Phones
OL-8131-01
TFTP Server1 (This
parameter is shown as
TFTP Server 1 when
the phone is
configured to operate
in a standard
Cisco Unified
CallManager
environment; in a
standard SIP
environment the
parameter is TFTP
Server.) IP address or URL of the TFTP
server from which a phone obtains
a profile. Required if the DHCP
server does not provide the TFTP
server address.
If you set the Alternate TFTP
parameter to Yes, you must enter a
non-zero value for the TFTP
Server1 parameter.
1. Unlock configuration parameters.
2. Set the TFTP Enabled parameter to
Yes.
3. Set the Alternate TFTP parameter to
Yes.
4. Scroll to the TFTP1 Server
parameter, press the Edit softkey,
and then enter a new TFTP server IP
address or URL.
5. Press the Validate softkey, and then
press the Save softkey.
TFTP Server 2 This parameter is read-only and the
value displayed, if any, is the
backup TFTP server specified in
DHCP Parameter 150. Display only—cannot configure.
Default Router IP address of the network gateway
used by the phone. You can use this
parameter to assign this address if
DHCP does not provide it.
If you assign a network gateway
address with this parameter, you
must also assign an IP address and
a subnet mask for the phone. See
the IP Address and the Subnet
Mask parameters in this table.
1. Unlock configuration parameters.
2. Set the DHCP Enabled parameter to
No.
3. Scroll to the Default Router
parameter, press the Edit softkey,
and then enter a new network
gateway IP address.
4. Press the Validate softkey, and then
press the Save softkey.
Table 4-1 Network Configuration Menu Parameters (continued)
Parameter Description To Change