Cisco 7912G - Manual (Page 137)

A-15
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SIP), Cisco Unified IP Phones
OL-8131-01
Appendix A Reference List of Parameters
Configuration Parameters
SIP Parameters
Table A-5 describes the SIP parameters that you can view through a phone’s
profile or through the SIP Parameters area on the phone’s web page.
Tip To access the SIP Parameters area directly from a web browser, enter
IP_address/SIPConfiguration, where IP_address is the IP address of your
Cisco Unified IP Phone.
Nprintf IP address and port of a
server to which
Cisco Unified
IP Phone
troubleshooting
messages are sent. Enter the extended IP address of the server to which
troubleshooting messages are sent and collected in a log
file.
The default value is 0, which specifies that no messages are
sent.
Note To collect troubleshooting messages, the prserv.exe
tool must be running on the server specified with
this parameter.
For more information about using Nprintf and preserv.exe
to collect troubleshooting information, see the
“Logging
Information for Troubleshooting” section on page 7-12 .
TraceFlags Enables specific trace
features when Nprintf
is set to a valid host
address and port. • 0=Disable debug messages.
• 1=Enable debug messages.
Value type: Bitmap.
Default value: 0x00000000
1. CDP = Cisco Discovery Protocol
Table A-4 Network Parameters (continued)
Parameter Description Usage