ClearOne PAN6400 - Manual (Page 14)

NetStreams Panorama System Installation Guide
2-4
All specifications subject to change without notification. All rights reserved. Copyright © 2006 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 78727 / www.netstreams.com.
NOTE
NOTE
The display connected
to the MONITOR ports
shows what is playing
on the display and
source currently lit on
the PAN6400 VDC
LEDs. If Sources 3 and
4 are playing on
different displays, and
the Display 2 and
Source 4 LEDs are on,
the MONITOR display
shows Source 4. The rear panel of the PAN6400 VDC has ports and the power input. Figure 2-2 shows
the rear panel.
Figure 2-2 PAN6400 VDC (rear panel)
Available ports include:

six RCA-type input/output ports for each of four video sources labeled S1 - S4

three RCA-type output ports labeled MONITOR for connecting a monitor to the
PAN6400 VDC at the headend which displays last selected source and room
Use a CAT5, 568a-
terminated cable for
Video Port connections.
For further information
on the VP500 or VP700,
see
Panorama Video
Ports: PANVP500 and
PANVP700
on page 2-5.

six RJ45 ports transmits the video signal to a VP500 or VP700 Video Port for use
with up to six displays

four IR input/output ports for each of four video sources labeled S1 - S4 and a
common input and output connection labeled C

two RS-232 ports (IO1 and IO2):
ˆ
IO1 - connects to the Musica MU5066ADC
ˆ
IO2 - connects to DigiLinX, another PAN6400 VDC (when integrated with
Musica), a computer, or other control devices

power - DC12V power supply and power cord (included).
Remote Control
The PAN6400 VDC comes with an IR remote that can control the PAN6400. The
remote can execute IR commands stored in the PAN6400 VDC, allowing the
PAN6400 to control sources. Use of the remote is covered in
Chapter 6, Using IR .
The PAN6400 VDC stores 10 IR codes for each source and 10 IR codes for each
display. Each of the 10 definable buttons on the Panorama remote access both a stored
IR command for a display and a source. Both commands execute simultaneously. See
PAN6400 VDC IR Storage and Access on page 6-4 for complete information on storing
and accessing IR commands.