Adding additional displays (cascade mode), Adding additional displays (cascade mode) -7, Adding additional displays – ClearOne PAN6400 User Manual
Page 25: Cascade mode), Display output ports, as discussed in, Adding additional displays (cascade, Mode), In cascade mode as discussed in, Adding, Additional displays (cascade mode)
Configuring Standalone Installations
3-7
All specifications subject to change without notification. All rights reserved. Copyright © 2006 NetStreams
Main +1 512.977-9393 / fax +1 512.977.9398 / Toll Free Technical Support +1 866-353-3496
3600 W. Parmer Lane, Suite 100; Austin, TX 7872
NOTE
NOTE
To make the connections for composite video and digital audio, complete the
following steps:
1.
Ensure power is off to all devices.
2.
Connect the composite video cable from the video out port of the source to the
PAN6400 VDC IN port (red) for that source.
The composite video
cable can be plugged
into the Pb, Pr, or Y IN
ports. However, once a
port has been used for
composite, all sources
must use that port. For
example, if source 1
plugs the composite
cable into the red (Pr)
port, the three remaining
sources must use the Pr
port for composite
cables.
3.
Connect the coaxial digital (S/PDIF) cable from the source to the PAN6400 VDC
IN port (green) for that source.
4.
Connect an IR Emitter to the PAN6400 VDC IR OUTPUT port for the source and
place the emitter end over the IR window on the front of the source.
5.
Connect the CAT5 cable from the display output on the PAN6400 VDC to the VIM
port on the VP700.
6.
Connect the VP700 to the display using a composite cable.
You can also route the video from the VP700 to an A/V Receiver and then to the
display.
7.
Connect the Y/Composite port of the VP700 to the digital audio in of the A/V
Receiver.
8.
Connect the IR Receiver to the IR IN port on the VP700 and place the IR Receiver
where it can receive a signal from the remote. See
on page 2-5 for information on effective IR Receiver
placement.
9.
Connect an IR Emitter to the IR Out port of the VP700 and place the emitter end
over the IR window on the display.
10.
Connect 5.1 or higher channel speakers from the output ports of the A/V Receiver.
11.
Turn power on to all devices.
Adding Additional Displays (Cascade Mode)
Only the number of
displays can be
increased by cascading,
not the number of
sources.
Cascading two or more PAN6400 VDCs allows you to distribute video and audio
signal to more than six displays. You can display four sources to hundreds of displays.
This can be useful in commercial environments, such as sports bars or airports, where
audio is routed separately and the video needs to be displayed on many displays.
As many as 100 PAN6400 VDCs can be cascaded in this manner, for a total of 600
displays.