Cardinal Industries 225 WEIGHT INDICATOR - Manual (Page 22)

INSTALLATION, CONT.
AC Output Relay Board(s), Cont.
225 Indicator
Figure No. 10
Relay Box Assembly RB4-ACOUT or RB8-ACOUT
P16
Re-Installing the Rear Panel
After all terminations have been made;
1. Remove the excess cable from the instrument enclosure and securely tighten each of
the cable gland connectors.
y Do not over-tighten these connectors but make certain they are snug.
y DO NOT USE TOOLS! Finger-tighten only!
2. Ensure any unused gland connectors are plugged and replace the rear panel.
3. Secure the rear panel with the 14 acorn nuts removed earlier, following a diagonal
pattern when tightening the acorn nuts.
8200-M538-O1
y 225 Installation
Page 18