Cardinal Industries 225 WEIGHT INDICATOR - Manual (Page 74)

CALIBRATION AND SETUP, CONT.
3. Zct=XXXXXXX (ZERO COUNT)
With the SCALE 1 CALIBRATION MENU di
8200-M538-O1
y 225 Installation
Page 70
splayed the current setting for the Zct=
o
eric keys, enter the
ER key to save the new
9. Note that the capacity can not exceed 7 digits or 9,999,999.
Ca
he calibration “C” numbers ( C1, C2, C3 and C4) represent the present calibration
ay be up to three (3) digits in length. These values are
ent calibration
settings (without using test weights) enter the calibration “C” numbers.
ote that XXX is the current value for
gs displayed match the numbers recorded
ress
turn to the SCALE 1 CALIBRATION
parameter will be shown. Note that XXXXXXX is the current value for the analog to
digital reading at zero, the Zero count. If the setting displayed is acceptable, proceed t
the next setup parameter.
Otherwise, press the 3 key, the ENTER key and then using the num
value for the zero load Zero count and then press the ENT
setting and return to the SCALE 1 CALIBRATION MENU. Allowable values are 1
through 9,999,99
libration “C” Numbers
T
settings. Each number m
established when the scale is calibrated. To return the indicator to its pres
6. C1=XXX
7. C2=XXX
8. C3=XXX
9. C4=XXX
With the SCALE 1 CALIBRATION MENU displayed the current setting for the C1=,
C2=, C3= and C4= parameters will be shown. N
CALIBRATION “C” NUMBERS
the calibration “C” number. If the settin
previously, proceed to the next setup parameter.
Otherwise, press the 6, 7, 8 or 9 key, (for the “C” number to be changed), the ENTER
key and then using the numeric keys, enter the value for the “C” number and then p
the ENTER key to save the new setting and re
MENU. Allowable values are 1 through 255.
If any components have been changed that affect calibration and/or the scale is
used in a commercial application and must be "Legal for Trade", calibration
parameters or the “C” numbers cannot be use to re-calibrate.