Cardinal Industries 225 WEIGHT INDICATOR - Manual (Page 58)

CALIBRATION AND SETUP, CONT.
16. CNV NET=YY.XX (CONVERTED UNITS NET WEIGHT PRINT LOCATION)
You must select LFT=NO, during Calibration and Setup to enable the Conve
Units Net Weight print feature. NOTE! The CNV NET= weight will only print if
the converted weight is greater than zero and the 225 in is the Net mode.
rted
,
17. ID=YY.XX (ID STORAGE NUMBER PRINT LOCATION)
ceptable, proceed to the next setup parameter.
g and
Print Tabs Setting Completed
With P
return
to SET
With PRINT TABBING MENU #2 displayed the current setting for the CNV NET=
parameter will be shown. Note that YY.XX is the current position for printing of the
Converted Units Net weight. If the position displayed is acceptable, proceed to the next
setup parameter.
numeric Otherwise, press the 1 and 6 keys, the ENTER key and then using the keys
enter the new print position and then press the ENTER key to save the new setting and
return to PRINT TABBING MENU #2.
With PRINT TABBING MENU #2 displayed the current setting for the ID= parameter
will be shown. Note that YY.XX is the current position for printing of the ID Storage
number. If the position displayed is ac
Otherwise, press the 1 and 7 keys, the ENTER key and then using the numeric keys,
enter the new print position and then press the ENTER key to save the new settin
return to PRINT TABBING MENU #2.
RINT TABBING MENU #2 displayed, press PREV (Navigation Keys UP Arrow) to
to PRINT TABBING MENU #1 or press EXIT (Navigation Keys Down Arrow) to return
UP MENU #2.
SETUP MENU #2
1. SERIAL
2. DIO
3. PRINT TABS
4. SETUP SCALE 1
5. CALIBRATE 1
Enter Selection: 0
` NEXT ^ PREV
With the SETUP MENU #2 displayed,
y Proceed to the next setup parameter.
y Press PREV (Navigation Keys UP Arrow) to return to SETUP MENU #1.
y Press NEXT (Navigation Keys Down Arrow) to proceed to the SETUP MENU #3.
8200-M538-O1
y 225 Installation
Page 54