Dell PowerEdge FX2/FX2s - Manual (Page 196)

-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
--------------------------------------------------------------------------
0 Management online PE-FN-410S-IOA PE-FN-410S-IOA 1-0(0-1864) 12
1 Standby card problem PE-FN-410S-IOA unknown 12
2 Member not present
3 Member not present
4 Member not present
5 Member not present
Card Problem — Resolved
Dell#show system brief
Stack MAC : 00:1e:c9:f1:04:82
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
----------------------------------------------------------------------
0 Management online PE-FN-410S-IOA PE-FN-410S-IOA 1-0(0-1864) 12
1 Standby online PE-FN-410S-IOA PE-FN-410S-IOA 1-0(0-1864) 12
2 Member not present
3 Member not present
4 Member not present
5 Member not present
Stack Unit in Card-Problem State Due to Configuration Mismatch
• Problem: A stack unit enters a Card-Problem state because there is a configuration mismatch
between the logical provisioning stored for the stack-unit number on the master switch and the
newly added unit with the same number.
• Resolution: From the master switch, reload the stack by entering the reload command in EXEC
Privilege mode. When the stack comes up, the card problem will be resolved.
Upgrading a Switch Stack
To upgrade all switches in a stack with the same Dell Networking OS version, follow these steps.
1. Copy the new Dell Networking OS image to a network server.
2. Download the Dell Networking OS image by accessing an interactive CLI that requests the server IP
address and image filename, and prompts you to upgrade all member stack units.
EXEC Privilege mode
upgrade system { flash: | ftp: | scp: | tftp: | usbflash: } partition
Specify the system partition on the master switch into which you want to copy the Dell Networking
OS image. The system then prompts you to upgrade all member units with the new Dell Networking
OS version.
The valid values are a: and b:.
3. Reboot all stack units to load the Dell Networking OS image from the same partition on all switches
in the stack.
CONFIGURATION mode
boot system stack-unit all primary system partition
4. Save the configuration.
EXEC Privilege
196 Stacking