Dell PowerEdge FX2/FX2s - Manual (Page 92)

0 packets, 0 bytes
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 05:29:16
To view only configured interfaces use the show interfaces configured command in EXEC Privilege
mode.
To determine which physical interfaces are available, use the show running-config command in EXEC
mode. This command displays all physical interfaces available on the switch, which is as shown in the
following example.
Dell#show running-config
Current Configuration ...
! Version 1-0(0-4)
! Last configuration change at Tue Mar 25 04:50:51 2014 by default
!
boot system stack-unit 0 primary tftp://10.11.8.12/dv-ci-stomp-tc-1-a1
!
redundancy auto-synchronize full
redundancy disable-auto-reboot stack-unit
!
logging coredump stack-unit all
!
hostname Dell
!
enable password 7 b125455cf679b208e79b910e85789edf
!
username admin password 7 1d28e9f33f99cf5c
!
enable restricted 7 e0f78bb16023c392
!
vlt domain 1
!
stack-unit 0 provision PE-FN-410S-IOA
--More--
92 Interfaces