Dell PowerEdge FX2/FX2s - Manual (Page 94)

advertise management-tlv system-name
dcbx port-role auto-downstream
no shutdown
Dell(conf-if-te-0/1)#
To view the interfaces in Layer 2 mode, use the show interfaces switchport command in EXEC
mode.
Management Interfaces
An Aggregator auto-configures with a DHCP-based IP address for in-band management on VLAN 1 and
remote out-of-band (OOB) management.
The IOM management interface has both a public IP and private IP address on the internal Fabric D
interface. The public IP address is exposed to the outside world for WebGUI configurations/WSMAN and
other proprietary traffic. You can statically configure the public IP address or obtain the IP address
dynamically using the dynamic host configuration protocol (DHCP).
Accessing an Aggregator
You can access the Aggregator using:
• Internal RS-232 using the chassis management controller (CMC). Telnet into CMC and do a connect
—b switch-id to get console access to corresponding IOM.
• External serial port with a universal serial bus (USB) connector (front panel): connect using the IOM
front panel USB serial line to get console access (Labeled as USB B).
• Telnet/ssh using the public IP interface on the fabric D interface.
• CMC through the private IP interface on the fabric D interface.
The Aggregator supports the management ethernet interface as well as the standard interface on any
front-end port. You can use either method to connect to the system.
Configuring a Management Interface
On the Aggregator, the dedicated management interface provides management access to the
system.You can configure this interface with Dell Networking OS, but the configuration options on this
interface are limited. You cannot configure gateway addresses and IP addresses if it appears in the main
routing table of Dell Networking OS. In addition, the proxy address resolution protocol (ARP) is not
supported on this interface.
For additional management access, IOM supports the default VLAN (VLAN 1) L3 interface in addition to
the public fabric D management interface. You can assign the IP address for the VLAN 1 default
management interface using the setup wizard or through the CLI.
If you do not configure the default VLAN 1 in the startup configuration using the wizard or CLI, by default,
the VLAN 1 management interface gets its IP address using DHCP.
To configure a management interface, use the following command in CONFIGURATION mode:
Command Syntax Command Mode Purpose
interface Managementethernet interface CONFIGURATION Enter the slot and the port (0).
94 Interfaces