Interface types, Viewing interface information – Dell PowerEdge FX2/FX2s User Manual

Page 91

Advertising
background image

• All interfaces are auto-configured as members of all (4094) VLANs and untagged VLAN 1. All VLANs

are up and can send or receive layer 2 traffic. You can use the Command Line Interface (CLI) or CMC

interface to configure only the required VLANs on a port interface.

Interface Types

The following interface types are supported on an Aggregator.

Interface Type

Supported

Modes

Default Mode

Requires

Creation

Default State

Physical

L2

10GbE uplink

No

No Shutdown (enabled)

Management

L3

L3

No

No Shutdown (enabled)

Port Channel

L2

L2

No

L2 - No Shutdown (enabled)

Default VLAN

L2 and L3

L2 and L3

(VLAN 1)

No

L2 - No Shutdown (enabled)L3 -

No Shutdown (enabled)

Non-default VLANs

(VLANs 2 - 4094)

L2

L2 and L3

Yes

L2 - No Shutdown (enabled)L3 -

No Shutdown (enabled)

Viewing Interface Information

To view interface status and auto-configured parameters use show commands.
The show interfaces command in EXEC mode lists all configurable interfaces on the chassis and has
options to display the interface status, IP and MAC addresses, and multiple counters for the amount and
type of traffic passing through the interface. If you configure a port channel interface, the show
interfaces command lists the interfaces configured in the port channel.

NOTE: To end output from the system, such as the output from the show interfaces command,

enter CTRL+C and the Dell Networking Operating System (OS) returns to the command prompt.

NOTE: The CLI output may be incorrectly displayed as 0 (zero) for the Rx/Tx power values. Perform

an simple network management protocol (SNMP) query to obtain the correct power information.

The following example shows the configuration and status information for one interface.

Dell#show interface tengig 0/7

TenGigabitEthernet 0/7 is up, line protocol is down

Hardware is DellEth, address is 00:1e:c9:de:04:9c

Current address is 00:1e:c9:de:04:9c

Server Port AdminState is N/A

Pluggable media not present

Interface index is 5313282

Internet address is not set

Mode of IPv4 Address Assignment : NONE

DHCP Client-ID :001ec9de049c

MTU 1554 bytes, IP MTU 1500 bytes

LineSpeed auto

Flowcontrol rx on tx off

ARP type: ARPA, ARP Timeout 04:00:00

Last clearing of "show interface" counters 05:30:18

Queueing strategy: fifo

Input Statistics:

Interfaces

91

Advertising