Arc Machines 207 - Manual (Page 10)

MODEL 207A AND 207A-1
OPERATION MANUAL
Doc. No. 740044
Rev F
SECTION I - INTRODUCTION
1.1 SAFETY PRECAUTIONS
WARNING: Keep hands and fingers clear from moving parts
such as fans, gears rotors, Wire Feed, Rotation and AVC
Mechanisms.
WARNING: The M-207A Power Supply is not intended for
pipe thawing or heating in any form.
WARNING: The M-207A weighs in excess of 75 lbs. Be sure
to follow local, OSHA, International or employers guidelines
for proper methods of lifting and re-locating this equipment.
1.2 OPERATIONAL PRECAUTIONS
The following is a check list for operating personnel to follow to insure minimum
system down-time due to improper operation and handling:
1. TOO AVOID severe equipment damage VERIFY that the M-207A is
connected to the correct Input AC power (see section 3.1).
2. Before operating, check all fittings and connectors for proper seating and that
all protective boots are in place. If not properly seated or protected, short
circuits, poor connections or inert gas leaks could occur.
3. The M-207A is intended for typical GTAW gases ONLY. NEVER CONNECT
OXYGEN OR ACETYLENE TO THE M-207A.
4. Before operating, insure that all cables are routed or protected in such a way
that they will not be subject to heat, equipment and/or personnel traffic. Insure
that the cables DO NOT come in contact with HOT PIPE.
5. When storing or handling cables, always keep the protective boots and dust
caps on all connectors and fittings until ready to install. A major cause of
downtime in any automatic welding system is improper care and use of cables.
1.5