Arc Machines 207 - Manual (Page 56)

MODEL 207A AND 207A-1
OPERATION MANUAL
Doc. No. 740044
Rev F
SECTION VI - PROGRAMMING
6.1
CREATE A WELD SCHEDULE
9. When the PRO key has been pressed, indicating the end of level
programming, the system will display the OVERRIDE screen:
USE F KEYS TO SELECT ITEM - %
PRESS ENTER KEY WHEN ALL % ARE SET
TIME AMP RPM PRG SLP PLS DLY
100 100 100 100 100 100 100
The system automatically defaults to 100 % override. This means the operator
can make up to a 100 % change to any of these functions.
10. If you wish to limit the amount of change to certain functions then use the F
key for that function and use the numeric keys to enter the desired % of change
to be allowed. When one F key is pressed, pressing another will turn the first
one off and activate the second function. When all OVERRIDE % are set,
press the ENTER key.
11. The system will then ask if you want to STORE the weld schedule in memory
or to MODIFY it. REMEMBER THAT UNTIL IT HAS BEEN STORED IT
DOES NOT EXIST IN MEMORY. It is usually better to STORE at this time
and if changes are needed, recall it from memory using the MODIFY function.
To STORE press the F key under the word STORE and then press ENTER.
To MODIFY press the F key under the word MODIFY and then press
ENTER and go to step 6.2.
6.2
MODIFY A WELD SCHEDULE
The OPERATE mode switch must be in the PROGRAM position to MODIFY.
Modifying an existing weld schedule in memory starts from the STATUS Screen
OR at the end of LEVEL 1 programming in the CREATE mode. If modifying
from the CREATE mode proceed to step 2.
1. Press the PRO key. Use the F key to select MODIFY and then press the
ENTER key. The system will then ask you what weld schedule number
you wish to MODIFY. Use the numeric keys to enter the number, verify and
then press the ENTER key.
6.4