AVer SEB5116 series - Manual (Page 54)

48
select a video cover area. To un-select the cover area, drag from down to up. Also, user can
click block one by one to select and un-select the cover area.
3.2.3 PTZ Camera Setting
Configure PTZ camera parameters and preset position. Click OK to save the setting, click Cancel to
exit without save. When PTZ camera is set, user can control PTZ camera through PTZ control panel
on preview and playback mode (see also
Chapter 2.3.1.1 Using PTZ Control Panel ).
i
In Select Cameras, SEB5108H series only has 8 channels will be available.
(1)
(2)
(3)
(4)
(5)
(1) Select Camera
Select the camera number that is a PTZ camera to configure.
(2) PTZ Setting
- Use PTZ: Enable/disable the PTZ camera function.
- Com Port: Select the com port that is connect with DVR system.
- ID: select the ID number for the camera.
- Baud Rate: Select the baud rate of com port which is connect with DVR system.
- Protocol: Select the protocol of PTZ camera. Please refer to your PTZ camera user ’s
manual.
(3) Preset Setting
- Preset Number: Set a camera lens to a position that user is defined. Select the Preset
number and using (5) PTZ control panel to adjust the camera lens to the wanted position.
Repeat to set reset of preset position.
- Dwell Time: Set a time for how long the PTZ camera stays in that position before it moves to
the next one.
- Restore AutoPan Time: Set a time period for restoring auto path function after the PTZ
camera has been moved. Mark the Restore AutoPan Time check box and select the time
period in second.
(4) Preview Screen