AVer SEB5116 series - Manual (Page 59)

53
- None: No any recording at all.
5. Click on the blocks to set the schedule or click All to select all. To un-select the specific schedule
blocks, click the None and click blocks to un-select. Click Clear will un-select all schedule block.
6. To store the setting, click Save.
7. To end Schedule Setting, click OK to exit and accept the setting and Cancel to exit.
3.4.2 Setup Recording Schedule
To setup recording schedule based on date, time, and record modes.
i
- Recording schedule must set in order to record.
- In Select Cameras, SEB5108H series only has 8 channels will be available.
To Set the Recording Schedule:
1. Click
> Schedule > Record tab.
2. Select the camera or mark Select All to select all cameras.
3. Mark Audio Enable if user wants to record audio.
4. Select the record mode. Click  to make a selection.
- Always Record
Record the video from the selected camera and save it to the designated storage path.
- Motion Record
Start recording the video from the selected camera only when the system detects movement.
Once a motion is detected, the system automatically saves the previous frames and stop
based on the Pre Record Time and After Record Time settings.
- Sensor Record
Start recording the video from the selected camera only when the sensor has been triggered.
Once a sensor is triggered, the system automatically saves the previous frames and stop
based on the Pre Record Time and After Record Time settings.