Rice Lake 920i Installation Manual V3.10 - Manual (Page 100)

94 920i Installation Manual
DIO.TRIG_SLOT.b#s Trigger output slot NONE, SLOT3
DIO.TRIG_PARAM.b#s Trigger output parameter value
Digital inputs and outputs are specified by bit number (b) and slot number (s)
Command Description Values
Table 9-8. DIG I/O Serial Commands
Command Description Values
ALG.ALIAS#s Analog output alias name
ALG.SOURCE#s Analog output source PROG, SCALEn
ALG.MODE#s Mode GROSS, NET
ALG.OFFSET#s Zero offset 0%, 20%
ALG.ERRACT#s Error action FULLSC, HOLD, ZEROSC
ALG.MIN#s Minimum value tracked 0–9999999
ALG.MINNEG#n Minimum value is negative OFF, ON
ALG.MAX#s Maximum value tracked 0–9999999
ALG.MAXNEG#n Maximum value is negative OFF, ON
ALG.ZERO#s Zero calibration 0–65535
ALG.SPAN#s Span calibration 0–65535
For commands ending with “#s”, s is the slot number. For dual-channel analog output cards,channel 2 is assigned to
ALGOUTs+14. For example, channel 2 of a dual analog output card in Slot 3 is assigned ALGOUT17.
Table 9-9. ALGOUT Serial Commands (Valid Only If Analog Output Card Is Installed)
Command Description Values
FB.BYTESWAP#s Swap data bytes NONE, BYTE, WORD, BOTH
FB.SIZE#s Number of bytes to transfer 2–128
For commands ending with “#s”, s is the slot number.
Table 9-10. FLDBUS Serial Commands (Valid Only If Fieldbus Card Is Installed)
Command Description Values
XP#s Extract probe temperature —
XPP#s Extract probe primary temperature
XPS#s Extract probe secondary temperature
XPT#s Extract probe tertiary temperature
XI#s Extract 0–20 mA value
XV#s Extract 0–10 V value
For commands ending with “#s”, s is the slot number.
Table 9-11. Analog Input Serial Commands (Valid Only If Analog Input Card Is Installed)