Rice Lake 920i Installation Manual V3.10 - Manual (Page 95)

Serial Commands 89
SC.ROC.REFRESH#n Rate-of-change refresh
interval 0.1–60
SC.RANGE1.MAX#n Weight maximum for first
range or interval weight
SC.RANGE2.MAX#n Weight maximum for second
range or interval weight
SC.RANGE3.MAX#n Weight maximum for third
range or interval weight
SC.ACCUM#n Accumulator enable ON, OFF
SC.VISIBLE#n Scale visibility ON, OFF
SC.PEAKHOLD#n Peak hold OFF, NORMAL, BI-DIR, AUTO
SC.WZERO#n Zero calibration —
SC.WVAL#n Test weight value test_weight_value
SC.WSPAN#n Span calibration —
SC.WLIN.F1#n–
SC.WLIN.F5#n Actual raw count value for
linearization points 1–5 0–16777215
SC.WLIN.V1#n–
SC.WLIN.V5#n Test weight value for
linearization points 1–5 0.000001–9999999
SC.WLIN.C1#n–
SC.WLIN.C5#n Calibrate linearization points
1–5 —
SC.LC.CD#n Deadload coefficient —
SC.LC.CW#n Span coefficient —
SC.LC.CZ#n Temporary zero —
SC.REZERO#n Rezero —
For commands ending with “#n”, n is the scale number.
Command Description Values
Table 9-3. SCALES Serial Commands (Continued)
Command Description Values
EDP.INPUT#p Port serial input function CMD, KEYBD, KBDPRG, SCALE, IND SC, DISPLAY, IQUBE
See the
iQUBE Installation Manual, PN 77224, for more information
about configuring iQUBE serial scales.
EDP.BAUD#p Port baud rate 300, 600, 1200, 2400, 4800, 9600, 19200, 28800, 38400, 57600,
115200
EDP.BITS#p Port data bits/parity 8NONE, 7EVEN, 7ODD, 8ODD, 8EVEN
EDP.TERMIN#p Port termination character CR/LF, CR
EDP.STOPBITS#p Port stop bits 2, 1
EDP.ECHO#p Port echo ON, OFF
EDP.RESPONSE#p Poer response ON, OFF
EDP.EOLDLY#p Port end-of-line delay 0–255 (0.1-second intervals)
EDP.HANDSHK#p Port handshaking OFF, XONXOFF, HRDWAR
EDP.PORTTYPE#p Port type 232, 485
EDP.DUPLEX#p Port RS-485 duplex HALF, FULL
Table 9-4. SERIAL Port Serial Commands