Rice Lake 920i Installation Manual V3.10 - Manual (Page 13)

Introduction 7
Version 3.00
• The desktop model of the
920i
has been
discontinued. Drawings and parts lists for the
desktop model have been removed from this
manual.
• Added support for multi-range and
multi-interval scale configurations.
• Zero tracking, zero range, and motion band
parameters (SCALES menu) have been
changed to allow numeric values.
• Added peak hold function to SCALES menu.
• Added last zero and temporary zero functions
to calibration menus to allow recalibration
based on previous zero values.
• Enhanced print formatting with addition of
audit format and twenty auxiliary formats.
• The SERIAL menu has been restructured to
provide additional parameters for configuring
RS-485 communications. See Figure 3-10 on
page 36.
• A new digital input count (DINCNT) setpoint,
used to count digital input pulses, has been
added to the supported setpoint kinds. See
Section 8.0 on page 67.
• A SENSE parameter has been added to
optionally invert the value of setpoint digital
outputs. See Section 8.0 on page 67.
• TRIGGER (digital output trigger) has been
added as a selection under the DIG I/O menu
(see Section 3.2.6 on page 47) for custom
applications.
• Support has been added for EtherNet/IP and
analog input/thermocouple option cards.