Rice Lake BCi Belt Scale - Installation and Operation Manual Version 2.03 - Manual (Page 41)

Installation and Operation Manual - Integrator Hardware Setup 35
Removal
Place the tip of your finger in the notched area near
the battery retaining spring and slide the battery out of
position on the CPU board.
Replacement
Before replacing the batter, place the integrator in
setup mode, then press
SAVE/EXIT to save the
battery-backed memory (NVRAM) to flash. This
operation save the latest configuration information.
Return to weigh mode, power off the integrator, and
replace the battery. Use care not to bend the battery
retaining spring.
When power is restored, a message is shown stating
that battery-backed memory is corrupt. Press
ENTER
to restore the value saved in flash memory.
Battery Removal
CAUTION
Risk of explosion if battery is replaced with incorrect type. Dispose of batteries per manufacturer
instruction.
3.6 Parts Kit Contents
The Parts kit content table lists the parts kit contents for the deep enclosure model of the BCi .
Table 3-6. Parts Kit Contents
PN Description
14626 Kep nuts, 8-32NC (4)
14862 Machine screws, 8-32NC x 3/8 (12)
15133 Lock washers, No. 8, Type A (4)
15144 Nylon washers (2)
15631 Cable ties (4–single A/D, 6–dual A/D)
15665 Reducing glands for 1/2 NPT cord grips (2)
15887 6-position screw terminal for load cell connection (1–single A/D, 2–dual A/D)
19538 Cord grip plugs (4–single A/D, 3–dual A/D)
30623 Fillister head screws, 8-32NC x 7/16 (2)
42149 Rubber feet for tilt stand (4)
42350 Capacity label (1–single A/D, 2–dual A/D)
53075 Cable shield ground clamps (4)
68403 Wing knobs for tilt stand (2)
70599 6-position screw terminals for J2 and J10 (2)
71125 3-position screw terminal for J11 (1)
71126 4-position screw terminal for J9 and optional keyboard connection (2)
75062 Sealing washers (14)