0 supervisor mode parameters, Supervisor mode parameters, Rate – Rice Lake BCi Belt Scale - Installation and Operation Manual Version 2.03 User Manual
Page 45
Installation and Operation Manual - Supervisor Mode Parameters
39
4.0
Supervisor Mode Parameters
Various parameters can be set by using the
Supervisor Mode
softkey from the main menu.
Note
All parameters must be entered prior to calibrating the unit.
Supervisor
Mode
SCALE #1
Reset
Totalizer
Diagnostics
11/23/2011
08:13AM
Rate
Speed
Load
Totalizer
tn/hr
ft/min
lb/ft
tn
293467.2
43.21
47.5
207467.8
Supervisor Mode
Softkey
Figure 4-1. Supervisor Mode Softkey Location
Press the
Supervisor Mode
softkey to access the following screen.
Exit=>
SCALE #1
Master
Totalizer
Integrator
Calibration
Time/Date
Belt
Calibration
11/23/2011
08:13AM
Admin. Passcode (numeric)
Scale Capacity (Max Rate)
Load Cell MV
Total LC Build
Rate Unit Time
Filter (s)
Filter Threshold (divisions)
Speed Unit Time
Fixed Speed
Unit of Measure
100.00
3.00000
600
hr
2.0
5
min
100.00
ft
Use up and down
a r ro w s o n t h e
integrator to scroll
t h ro u g h v a ri o u s
parameters.
Figure 4-2. Supervisor Mode Parameters
Use the
up
and
down
arrow keys on the integrator to navigate the parameter list. Use the
enter
key to select the
parameter to edit. If the parameter is a value that can be entered, a user prompt will open. The operator can then
key in the new value and press
enter
to accept the new value. If the parameter has a list of available values, the
value will scroll through all available selections.