Rice Lake CB-2 Concrete Batch Controller Version 1.0 User Manual
Page 35
Configuration of User Parameters
31
Intervals & Timers
ADMIN Menu
Parameter
Choices
Description
Level 2 Sub-menu
INTERVALS & TIMERS
Level 3 Sub-menu ADMIN MENU/INTERVALS & TIMERS
Max Time Between Pulses
Numeric (seconds)
You can set the maximum amount of time desired between pulses using the
numeric keypad. Increments are set up in seconds.
Start Conveyor Warning Time
You can set the amount of time desired for the warning signal to come on
indicating that the conveyor is about to start. Increments are set up in
seconds.
Agg Conveyor Run-out Time
Print Line Delay
You can set up a length of time in seconds that the printed ticket is delayed
between the lines.
Beep Duration
Length of time that the warning beep is activated. Increments are set up in
seconds.
Display Time
This is the length of time that the display is shown on the monitor. Increments
are set up in seconds.
Data Entry Timeout
Configuration Exit Timeout
Password Timeout
This is the length of time that one can enter a password. Increments are set
up in seconds.
Start Simulation Softkey
No
Yes
Select Yes to activate the start simulation of the CB-2. By activating this, the
CB-2 will simulate a batch sequence.