Rice Lake IQ Plus 355 Installation Manual V1.17 - Manual (Page 36)

32 IQ plus 355 Installation Manual
6.1.5 Normal Mode Commands
The serial transmit weight data commands (see Table 6-11) transmit data to the EDP port on demand. The SX
and EX commands are valid only in normal operating mode; all other commands are valid in either setup or
normal mode.
Command Description Values
GFMT Gross demand print format string See Section 6.0 on page 32 for detailed information
NFMT Net demand print format string
Table 6-8. PFORMT EDP Commands
Command Description Values
DIGIN1
DIGIN2 Digital input function OFF, ZERO, TARE, NT/GRS, UNITS, DSPTAR, PRINT, CLRCN,
KBDLOC, HOLD
Table 6-9. DIG IN EDP Commands
Command Description Values
SOURCE1 Analog output source GROSS, NET
OFFSET Zero offset 0%, 20%
ERRACT Error action FULLSC, HOLD, ZEROSC
MIN Minimum value tracked 0–999 990
MAX Maximum value tracked 0–999 990
ZERO1 Zero calibration 0–16 383
SPAN1 Span calibration 0–16 383
Table 6-10. ALGOUT EDP Commands
Command Description Response Format
SX Start EDP streaming OK or ??
EX Stop EDP streaming OK or ??
KNEWID Set or query product ID number nnnnnnn
RS Reset system —
XG Transmit gross weight in displayed units nnnnnn UU
where nnnnnn is the weight value, UU is the units. XN Transmit net weight in displayed units
XT Transmit tare weight in displayed units
XG2 Transmit gross weight in non-displayed units
XN2 Transmit net weight in non-displayed units
XT2 Transmit tare weight in non-displayed units
XE Query system error conditions nnnnn nnnnn
See Section 7.1.2 on page 36 for detailed information about
the XE command response format.
Table 6-11. Normal Mode EDP Commands