Rice Lake IQ Plus 355 Installation Manual V1.17 - Manual (Page 37)

EDP Commands 33
310 Command 355 Command Description
AZ KZERO Sets scale to zero. Valid only in Operate Mode.
FT KTARE Performs a front panel tare operation. Entering “FT <EOL>” acquires a tare like pressing
the TARE key.
CT Clear Tare Tare out (removes the tare value)
LB KPRIM Selects “lb” for weight units (if set up for “lb” or “kg” units mode)
KG KSEC Selects “kg” for weight units (if set up for “lb” or Kg” units mode)
GN KGROSSNET Simulates a GROSS/NET key press. Entering “GN <EOL>” toggles between the gross
and net display mode.
PR KPRINT Sends formatted weight data to either or both serial ports.
RS RS Resets system.
SX SX Starts continuous serial transmission on the EDP port using the selected serial output
data format. Serial transmission stops in SETUP mode.
EX EX Ends continuous serial transmision on the EDP port.
XG XG Transmits GROSS [9 characters, leading zeros suppressed (spaces), decimal point if
applicable, minus sign to left of first active digit]. Valid only in Operate Mode.
XN XN Transmits NET [9 characters, leading zeros suppressed (spaces), decimal point if
applicable, minus sign to left fo first active digit]. Valid only in Operate Mode.
XT XT Transmits TARE [9 characters, leading zeros suppressed (spaces), decimal point if
applicable, minus sign to left fo first active digit]. Valid only in Operate Mode.
XD P command Transmits the value currently displayed.
XS S command Transmits a single serial string from the EDP port in the selected output format.
Table 5-12 IQ310A Commands